Try Before You Buy

Download a free sample of any of our exam questions and answers

  • 24/7 customer support, Secure shopping site
  • Free One year updates to match real exam scenarios
  • If you failed your exam after buying our products we will refund the full amount back to you.

2024 Updated Fortinet NSE7_SDW-7.0 Dumps PDF - Want To Pass NSE7_SDW-7.0 Fast [Q12-Q30]

Share

2024 Updated Fortinet NSE7_SDW-7.0 Dumps PDF - Want To Pass NSE7_SDW-7.0 Fast

NSE7_SDW-7.0 Practice Exam Dumps - 99% Marks In Fortinet Exam

NEW QUESTION # 12
Which diagnostic command can you use to show the configured SD-WAN zones and their assigned members?

  • A. diagnose sys sdwan service
  • B. diagnose sys sdwan interface
  • C. diagnose sys sdwan member
  • D. diagnose sys sdwan zone

Answer: D


NEW QUESTION # 13
Which two settings can you configure to speed up routing convergence in BGP? (Choose two.)

  • A. set-route-tag
  • B. update-source
  • C. link-down-failover
  • D. holdtime-timer

Answer: C,D


NEW QUESTION # 14
Refer to the exhibit.

Based on the output shown in the exhibit, which two criteria on the SD-WAN member configuration can be used to select an outgoing interface in an SD-WAN rule? (Choose two.)

  • A. Set load-balance-mode source-ip-ip-based.
  • B. Set priority 10.
  • C. Set source 100.64.1.1.
  • D. Set cost 15.

Answer: B,D


NEW QUESTION # 15
Refer to the exhibit.

Which are two expected behaviors of the traffic that matches the traffic shaper? (Choose two.)

  • A. The number of simultaneous connections among all source IP addresses cannot exceed five connections.
  • B. The number of simultaneous connections allowed for each source IP address cannot exceed five connections.
  • C. The traffic shaper limits the bandwidth of each source IP address to a maximum of 625 KB/sec.
  • D. The traffic shaper limits the combined bandwidth of all connections to a maximum of 5 MB/sec.

Answer: B,C


NEW QUESTION # 16
What are two reasons why FortiGate would be unable to complete the zero-touch provisioning process? (Choose two.)

  • A. FortiDeploy has connected with FortiGate and provided the initial configuration to contact FortiManager
  • B. The zero-touch provisioning process has completed internally, behind FortiGate.
  • C. A factory reset performed on FortiGate.
  • D. The FortiGate cloud key has not been added to the FortiGate cloud portal.
  • E. FortiGate has obtained a configuration from the platform template in FortiGate cloud.

Answer: B,D


NEW QUESTION # 17
Refer to the exhibit.

Based on the exhibit, which statement about FortiGate re-evaluating traffic is true?

  • A. Changes have been made on firewall policy ID 1 on FortiGate.
  • B. FortiGate has terminated the session after a change on policy ID 1.
  • C. Firewall policy ID 1 has source NAT disabled.
  • D. The type of traffic defined and allowed on firewall policy ID 1 is UDP.

Answer: A


NEW QUESTION # 18
Which diagnostic command can you use to show the member utilization statistics measured by performance SLAs for the last 10 minutes?

  • A. diagnose sys sdwan log
  • B. diagnose sys sdwan intf-sla-log
  • C. diagnose sys sdwan health-check
  • D. diagnose sys sdwan sla-log

Answer: D


NEW QUESTION # 19
Refer to the exhibit.

Based on the exhibit, which statement about FortiGate re-evaluating traffic is true?

  • A. Changes have been made on firewall policy ID 1 on FortiGate.
  • B. FortiGate has terminated the session after a change on policy ID 1.
  • C. Firewall policy ID 1 has source NAT disabled.
  • D. The type of traffic defined and allowed on firewall policy ID 1 is UDP.

Answer: A


NEW QUESTION # 20
Refer to the exhibit.

Which conclusion about the packet debug flow output is correct?

  • A. The reply traffic exceeded the maximum bandwidth configured in the traffic shaper, and the packet was dropped.
  • B. The original traffic exceeded the maximum bandwidth configured in the traffic shaper, and the packet was dropped.
  • C. The original traffic exceeded the maximum bandwidth of the outgoing interface, and the packet was dropped.
  • D. The original traffic exceeded the maximum packets per second of the outgoing interface, and the packet was dropped.

Answer: B


NEW QUESTION # 21
Which two performance SLA protocols enable you to verify that the server response contains a specific value? (Choose two.)

  • A. icmp
  • B. http
  • C. twamp
  • D. dns

Answer: B,D

Explanation:
Pages 85,86 in Study guide 7.0 Pages 100,101 in Study guide 7


NEW QUESTION # 22
Which statement about using BGP for ADVPN is true?

  • A. You must configure BGP communities.
  • B. You must configure AS path prepending.
  • C. You must use BGP to route traffic for both overlay and underlay links.
  • D. IBGP is preferred over EBGP, because IBGP preserves next hop information.

Answer: D


NEW QUESTION # 23
Refer to the exhibits.
Exhibit A -

Exhibit B -

Exhibit A shows the SD-WAN performance SLA and exhibit B shows the SD-WAN member status, the routing table, and the performance SLA status.
If port2 is detected dead by FortiGate, what is the expected behavior?

  • A. Host 8.8.8.8 is reachable through port1 and port2.
  • B. Port2 becomes alive after three successful probes are detected.
  • C. FortiGate removes all static routes for port2.
  • D. The administrator manually restores the static routes for port2, if port2 becomes alive.

Answer: C

Explanation:
This is due to Update static route is enable which removes the static route entry referencing the interface if the interface is dead


NEW QUESTION # 24
Refer to the exhibit.

Which statement explains the output shown in the exhibit?

  • A. FortiGate performed standard FIB routing on the session.
  • B. FortiGate used 192.2.0.1 as the gateway for the original direction of the traffic.
  • C. FortiGate will not re-evaluate the session following a firewall policy change.
  • D. FortiGate must re-evaluate the session due to routing change.

Answer: D


NEW QUESTION # 25
Refer to the exhibit.

Based on the exhibit, which two actions does FortiGate perform on traffic passing through port2? (Choose two.)

  • A. FortiGate does not change the routing information on existing sessions that use a valid gateway, after a route change.
  • B. FortiGate performs routing lookups for new sessions only, after a route change.
  • C. FortiGate always blocks all traffic, after a route change.
  • D. FortiGate flushes all routing information from the session table, after a route change.

Answer: A,B


NEW QUESTION # 26
Refer to the exhibits.
Exhibit A -

Exhibit B -

Exhibit A shows the traffic shaping policy and exhibit B shows the firewall policy.
The administrator wants FortiGate to limit the bandwidth used by YouTube. When testing, the administrator determines that FortiGate does not apply traffic shaping on YouTube traffic.
Based on the policies shown in the exhibits, what configuration change must be made so FortiGate performs traffic shaping on YouTube traffic?

  • A. Application control must be enabled on the firewall policy.
  • B. Web filtering must be enabled on the firewall policy.
  • C. Individual SD-WAN members must be selected as the outgoing interface on the traffic shaping policy.
  • D. Destination internet service must be enabled on the traffic shaping policy.

Answer: A


NEW QUESTION # 27
Which two interfaces are considered overlay links? (Choose two.)

  • A. Physical
  • B. GRE
  • C. IPsec
  • D. LAG

Answer: B,C


NEW QUESTION # 28
What is the route-tag setting in an SD-WAN rule used for?

  • A. To indicate the members that can be used to route SD-WAN traffic.
  • B. To indicate the routes that can be used for routing SD-WAN traffic.
  • C. To indicate the routes for health check probes.
  • D. To indicate the destination of a rule based on learned BGP prefixes.

Answer: D


NEW QUESTION # 29

Exhibit B -

Exhibit A shows the system interface with the static routes and exhibit B shows the firewall policies on the managed FortiGate.
Based on the FortiGate configuration shown in the exhibits, what issue might you encounter when creating an SD-WAN zone for port1 and port2?

  • A. port1 is referenced in a firewall policy.
  • B. port1 and port2 are not administratively down.
  • C. port2 is referenced in a static route.
  • D. port1 is assigned a manual IP address.

Answer: A


NEW QUESTION # 30
......

Updated Verified NSE7_SDW-7.0 Q&As - Pass Guarantee: https://www.braindumpsit.com/NSE7_SDW-7.0_real-exam.html

NSE7_SDW-7.0 Certification with Actual Questions: https://drive.google.com/open?id=1J23dtlQ8fW4X-uiD3fU7BCoAb3axT6MQ